• This electronic component is designed and manufactured for use in general electronic equipment. • Würth Elektronik must be asked for a written approval (following the certain PPAP level procedure) before incorporating the components into any equipment in the field such as military, aerospace, aviation, nuclear control, submarine, transportation (automotive control, train control, ship control), transportation signal, disaster prevention, medical, public information network etc. where higher safety and reliability are especially required and/or if there is the possibility of direct damage or human injury. • Electronic components that will be used in safety-critical or high-reliability applications, should be pre-evaluated by the customer. • Direct mechanical impact to the product shall be prevented as material of the body, pins or termination could flake or in the worst case it could break. • Avoid any water or heavy dust on capacitors surface, which may cause electrical leakage, damage, overheating or corrosion. • Würth Elektronik products are qualified according to international standards, which are listed in each product reliability report. Würth Elektronik does not warrant any customer qualified product characteristic, beyond Würth Elektronik specifications, for its validity and sustainability over time. • The responsibility for the applicability of the customer specific products and use in a particular customer design is always within the authority of the customer. All technical specifications for standard products also apply to customer specific products. • The component is designed and manufactured to be used within the datasheet specified values. If the usage and operation conditions specified in the datasheet are not met, the body, pins or termination may be damaged or dissolved. • Do not apply any kind of flexural or compressive force onto soldered or unsoldered component. • The capacitance tolerance as specified within the datasheet is only valid on the date of delivery and according specified measurement criteria.
| Stock | In Stock |